Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE
  1. Coat a new O-ring with ATF and install it to the transmission wire.

  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    C187492E03
  1. Connect the transmission wire connector.

    HINT:
    Push up the lever until the claw of the transmission wire connector makes a connection sound.



2. CONNECT TRANSMISSION WIRE
  1. Connect the 9 solenoid valve connectors.

  1. Coat the ATF temperature sensor O-ring with ATF.

  1. Install the ATF temperature sensor and the temperature sensor clamp with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the wire harness clamp.

  1. Install the valve body wire harness clamp with the bolt.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
  1. Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.

  1. Install the valve body oil strainer assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL TRANSMISSION OIL CLEANER MAGNET


    C109359E04
  1. Install the 3 transmission oil cleaner magnets to the automatic transmission oil pan sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Transmission Oil Cleaner Magnet



5. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
  1. Install a new automatic transmission oil pan gasket and the automatic transmission oil pan sub-assembly with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

    NOTICE:
    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.



6. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)