Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)


2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    C256218
  1. Remove the 20 bolts, automatic transmission oil pan sub-assembly and the automatic transmission oil pan gasket.

    NOTICE:
    Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all the bolts and carefully remove the automatic transmission oil pan sub-assembly.



3. REMOVE TRANSMISSION OIL CLEANER MAGNET


    C109359E04
  1. Remove the 3 transmission oil cleaner magnets from the automatic transmission oil pan sub-assembly.
    Text in Illustration 
    *1
    Transmission Oil Cleaner Magnet



    AT00103E05
  1. Examine the particles in the automatic transmission oil pan sub-assembly.

    1. Collect any steel chips with the removed transmission oil cleaner magnets. Carefully inspect the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the transmission oil cleaner magnets to anticipate the type of wear you will find in the automatic transmission assembly.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bush wear



4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C258476
  1. Remove the 4 bolts and the valve body oil strainer assembly.

    NOTICE:
    Be careful as some fluid will come out of the valve body oil strainer assembly.



    C258477E01
  1. Remove the O-ring from the valve body oil strainer assembly.
    Text in Illustration 
    *1
    O-ring



5. DISCONNECT TRANSMISSION WIRE


    C231586
  1. Remove the bolt and the temperature sensor clamp.

  1. Separate the ATF temperature sensor.



    C257575
  1. Remove the bolt and the valve body wire harness clamp.

  1. Disengage the wire harness clamp.



    C122840
  1. Disconnect the 9 solenoid valve connectors.



6. REMOVE TRANSMISSION WIRE


    C187492E02
  1. Disconnect the transmission wire connector.

    HINT:
    Disengage the claw, press down the lever, and disconnect the transmission wire connector.



    C099927E01
  1. Remove the bolt and pull out the transmission wire.



    C101505E05
  1. Remove the O-ring from the transmission wire.
    Text in Illustration 
    *1
    O-ring