TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
Inspect the one-way clutch.
![]() |
Install SST into the inner race of the one-way clutch.
Set SST so that it fits in the notch of the torque converter hub and the outer race of the one-way clutch.
![]() |
With the torque converter assembly standing on its side, check that the clutch locks when SST is turned counterclockwise and rotates freely and smoothly when SST is turned clockwise.
![]() | Lock |
![]() | Free |
![]() |
Determine the condition of the torque converter assembly.
| *a | Sample showing maximum allowable amount of powder in ATF |
Check that the following conditions are met:
Replace the ATF in the torque converter assembly.
If the ATF is discolored and/or has a foul odor, stir the ATF in the torque converter assembly thoroughly and drain the ATF with the torque converter assembly facing upward.
Clean and check the transmission oil cooler.
![]() |
If the torque converter assembly is inspected or the ATF is replaced, clean the transmission oil cooler.
If the ATF is cloudy, inspect the transmission oil cooler.
![]() |
Prevent deformation of the torque converter assembly and damage to the oil pump gear.
| *a | Correct |
| *b | Incorrect |
| *c | Bottom is damaged |
When any marks due to interference are found on the end of a bolt for the torque converter assembly and on the bottom of the bolt hole, replace the bolt and torque converter assembly.
Make sure all of the bolts are the same length.
Make sure no spring washers are missing.
| 2. INSPECT DRIVE PLATE |
Check the drive plate for damage.
![]() |
Set up a dial indicator and measure the runout of the 6 portions around the torque converter contact surfaces.
![]() | Measuring Point |