Home › Engine / Hybrid System › FA20 ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
(Click here)


2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
(Click here)


3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    A276036E01
  1. Using SST, hold the crankshaft.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A276896
  1. Remove the 8 bolts, drive plate and ring gear sub-assembly and rear drive plate spacer.



4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


    C258509E01
  1. Put the matchmarks on the clutch cover assembly and the flywheel sub-assembly.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen the 6 bolts one turn at a time until spring tension is released.

  1. Remove the 6 bolts and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
  1. Remove the clutch disc assembly.

    NOTICE:
    Keep the lining part of the clutch disk and the surfaces of the pressure plate and flywheel free of oil and foreign matter.



6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    A276036E01
  1. Using SST, hold the crankshaft.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A276046
  1. Remove the 8 bolts and flywheel sub-assembly.



7. REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE
  1. Remove the No. 1 crankshaft position sensor plate.



8. REMOVE REAR ENGINE OIL SEAL


    A276048E01
  1. Using a knife, cut through the oil seal lip.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Cut position

  1. Using a screwdriver with its tip taped, pry out the rear engine oil seal.

    NOTICE:
    After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

    HINT:
    Tape the screwdriver tip before use.