Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY

REAR DRIVE SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(Click here)


2. REMOVE REAR AXLE SHAFT NUT LH


C259939
  1. Using SST and a hammer, release the staked part of the rear axle shaft nut.

    SST
    09930-00010  

    NOTICE:
    1. Do not grind the SST.
    2. Release the staked part of the nut completely; otherwise the threads of the drive shaft may get damaged.

  1. Remove the rear axle shaft nut.



3. REMOVE REAR DRIVE SHAFT ASSEMBLY LH


    C261034
  1. Using a plastic hammer, separate the rear drive shaft assembly LH from the rear axle carrier. If it is difficult to separate, tap the end of the rear drive shaft assembly LH using a brass bar and a hammer.

  1. Remove the rear drive shaft assembly LH.

    NOTICE:
    1. Be careful not to damage the joint boot or speed sensor.
    2. Do not push out the rear axle carrier excessively.



4. REMOVE REAR AXLE SHAFT NUT RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE REAR DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.