Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY

REAR DIFFERENTIAL CARRIER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. DRAIN DIFFERENTIAL OIL


    C256680
  1. Using a hexagon wrench 10 mm, remove the rear differential filler plug and gasket.



    C256681
  1. Using a hexagon wrench 10 mm, remove the rear differential drain plug and gasket to drain the differential oil.



3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(Click here)


4. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY


    C256678
  1. Support the rear differential carrier assembly with a transmission jack.



    C256679
  1. Remove the 5 bolts, rear upper differential mount stopper and rear lower differential mount stopper.

  1. Lower the transmission jack slowly.



    C257535
  1. Using a SST, disconnect the rear drive shaft assembly from the rear differential carrier assembly as shown in the illustration.

    SST
    09520-01010  
    09520-24010   (09520-32040)



    C262320
  1. Lower the transmission jack and pull off the rear drive shaft assembly from the rear differential carrier assembly, and then remove the rear differential carrier assembly.

    HINT:
    C262321
    Tie the disconnected rear drive shaft with a rope.