Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB

FRONT AXLE HUB > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
  1. Install the front axle hub sub-assembly to the steering knuckle with the 4 new bolts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }

    NOTICE:
    1. Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle.
    2. Do not allow any foreign matter such as dirt or dust to enter between the front axle hub sub-assembly.



2. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    C257546
  1. Using a dial indicator, check for looseness near the center of the front axle hub.

    Maximum looseness:
    0.05 mm (0.00196 in.)

    NOTICE:
    If the looseness is more than the maximum, replace the front axle hub and bearing assembly.



3. INSPECT FRONT AXLE HUB RUNOUT


    C257547
  1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum runout:
    0.05 mm (0.00196 in.)

    NOTICE:
    If the looseness is more than the maximum, replace the front axle hub and bearing assembly.



4. INSTALL FRONT SPEED SENSOR LH
  1. Install the bolt and speed sensor front to the steering knuckle.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front disc brake dust cover.



5. INSTALL FRONT DISC
  1. When reusing the disc

    1. Align the matchmarks placed when removing, and install the front disc to the axle hub.

  1. When replacing the front disc

    1. Install a new front disc to the axle hub and measure the disc runout (Click here).

  1. Temporarily tighten the hub nut and fix the front disc to the axle hub.



6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Install the front disc brake caliper assembly to the steering knuckle with the 2 new bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



7. INSTALL FRONT WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



8. INSPECT SPEED SENSOR SIGNAL
(Click here)