Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB

FRONT AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

    NOTICE:
    Hang the caliper using a piece of string or equivalent.



3. REMOVE FRONT DISC


    C184280E03
  1. Place matchmarks on the front disc and front axle hub.

    HINT:
    It is not necessary when replacing the disc.

    Text in Illustration 
    *a
    Matchmark

  1. Remove the front disc.



4. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    C257546
  1. Using a dial indicator, check for looseness near the center of the front axle hub.

    Maximum looseness:
    0.05 mm (0.00196 in.)

    NOTICE:
    If the looseness is more than the maximum, replace the front axle hub and bearing assembly.



5. INSPECT FRONT AXLE HUB RUNOUT


    C257547
  1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum runout:
    0.05 mm (0.00196 in.)

    NOTICE:
    If the looseness is more than the maximum, replace the front axle hub and bearing assembly.



6. INSTALL FRONT DISC
  1. When reusing the disc

    1. Align the matchmarks placed when removing, and install the front disc to the axle hub.

  1. When replacing the front disc

    1. Install a new front disc to the axle hub and measure the disc runout (Click here).

  1. Temporarily tighten the hub nut and fix the front disc to the axle hub.



7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Install the front disc brake caliper assembly to the steering knuckle with the 2 new bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }