Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
(Click here)


2. REMOVE FRONT DISC BRAKE DUST COVER LH


    C257512
  1. Remove the 3 bolts and the front disc brake dust cover LH.



3. DISCONNECT TIE ROD SUB-ASSEMBLY LH


    C257549
  1. Remove the cotter pin and nut.

  1. Install the SST (spacer B) to the tie rod assembly.

    NOTICE:
    As SST may get damaged, make sure the space between the tie rod and the spacers is not less than 1 mm (0.0394 in.).



  1. Using SST, disconnect the tie rod assembly.


    C259936E02


    Text in Illustration 
    *1
    Nut
    *2
    Body
    *3
    Claw
    *4
    SST (Spacer B)
    *a
    1 mm (0.0394 in.)
    *b
    Place a Wrench Here
    V100135
    Molybdenum Grease
    V100136
    Turn
    SST
    09960-20010   (09961-02010, 09961-02060)

    CAUTION:
    Apply the molybdenum grease to the end and threads of the SST bolt.

    NOTICE:
    1. Install SST so that the claw and body are parallel.
    2. Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
    3. Do not damage the dust cover on the tie rod end sub-assembly.
    4. Do not damage the tie-rod end.
    5. Do not damage the ball joint dust cover.
    6. Do not damage the steering knuckle.



4. REMOVE FRONT LOWER SUSPENSION ARM ASSEMBLY LH


    C256600
  1. Remove the cotter pin and nut.

  1. Install the SST (spacer B) to the front lower suspension arm assembly LH.

    NOTICE:
    As SST may get damaged, make sure the space between the front lower suspension arm assembly LH and the spacers is not less than 1 mm (0.0394 in.).



  1. Using SST, disconnect the front lower suspension arm assembly LH.


    C256684E02


    Text in Illustration 
    *1
    Nut
    *2
    Body
    *3
    Claw
    *4
    SST (Spacer B)
    *a
    1 mm (0.0394 in.)
    *b
    Place a Wrench Here
    V100135
    Molybdenum Grease
    V100136
    Turn
    SST
    09960-20010   (09961-02010, 09961-02060)

    CAUTION:
    Apply the molybdenum grease to the end and threads of SST bolt.

    NOTICE:
    1. Install SST so that the claw and body are parallel.
    2. Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
    3. Do not damage the dust cover on the front suspension lower arm assembly.
    4. Do not damage the front lower arm sub-assembly.
    5. Do not damage the front disc brake dust cover.
    6. Do not damage the steering knuckle.



5. REMOVE STEERING KNUCKLE LH


    C256596
  1. Remove the steering knuckle LH with the 2 bolts and 2 nuts.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.