Home › Drivetrain ยท CLUTCH › CLUTCH UNIT

CLUTCH UNIT > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(Click here)


2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY


    C258506
  1. Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transmission assembly.



3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY


    C262732
  1. Disengage the 2 release bearing hub clips and remove the clutch release bearing assembly from the clutch release fork sub-assembly.



4. REMOVE RELEASE BEARING HUB CLIP
  1. Remove the 3 release bearing hub clips from the clutch release bearing assembly.



5. REMOVE CLUTCH RELEASE FORK BOOT


    C258507
  1. Remove the clutch release fork boot from the manual transmission assembly.



6. REMOVE RELEASE FORK SUPPORT


    C258508
  1. Remove the release fork support from the manual transmission assembly.



7. REMOVE CLUTCH COVER ASSEMBLY


    C258509E01
  1. Put the matchmarks on the clutch cover assembly and the flywheel sub-assembly.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen the 6 bolts one turn at a time until spring tension is released.

  1. Remove the 6 bolts and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



8. REMOVE CLUTCH DISC ASSEMBLY
  1. Remove the clutch disc assembly.

    NOTICE:
    Keep the lining part of the clutch disk and the surfaces of the pressure plate and flywheel free of oil and foreign matter.