Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the cruise control system.
  2. *: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the ignition switch off.

    2. Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
    1. Use the GTS to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTC*
      Refer to DTC Check / Clear (Click here).
    1. Check for DTCs and note any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

      Result:
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    GO TO DTC CHART (Click here )
    A


    5.ROAD TEST
    1. Perform the road test (Click here).

    2. Check that cruise control is not canceled by other than canceling operations by the driver.

      Result:
      Result
      Proceed to
      Cruise control is cancelled
      A
      Cruise control is not cancelled
      B



    B.
    GO TO STEP 8
    A


    6.CHECK "CANCEL CODE"*

      HINT:
      The driver's history of canceling cruise control is also stored.

    1. Check "CANCEL CODE" (Click here).

      Result:
      Result
      Proceed to
      "CANCEL CODE" is not detected
      A
      "CANCEL CODE" is detected
      B



    B.
    ADJUST, REPAIR OR REPLACE ACCORDING TO "CANCEL CODE"
    A


    7.PROBLEM SYMPTOMS TABLE
      Refer to Problem Symptoms Table (Click here).

      Result:

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
    A


    8.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)


    NEXT


    9.ADJUST, REPAIR OR REPLACE

      NEXT


      10.CONFIRMATION TEST

        NEXT

        END