Home › Engine / Hybrid System › FA20 FUEL › FUEL INJECTOR (for Direct Injection)

FUEL INJECTOR (for Direct Injection) > REMOVAL

for Preparation Click here



1. REMOVE INTAKE MANIFOLD
(Click here)


2. REMOVE NO. 2 FUEL DELIVERY PIPE


    A279756
  1. Using a union nut wrench, loosen the 2 union nuts and remove the No. 2 fuel delivery pipe.

    NOTICE:
    When removing the No. 2 fuel delivery pipe, pull it out in a straight line to avoid damaging the O-ring seal surface of the fuel delivery pipe LH.



3. REMOVE FUEL DELIVERY PIPE


    A279757
  1. Remove the 3 bolts.

  1. Using a union nut wrench, loosen the 2 union nuts and remove the fuel delivery pipe.



4. REMOVE FUEL DELIVERY PIPE LH


    A279758
  1. Disconnect the 2 fuel injector assembly connectors.



    A279759
  1. Remove the 2 bolts and fuel delivery pipe LH.



5. REMOVE FUEL DELIVERY PIPE RH


    A279760
  1. Disconnect the fuel pressure sensor connector and 2 fuel injector assembly connectors.



    A279761
  1. Remove the 2 bolts and fuel delivery pipe RH.



6. REMOVE FUEL INJECTOR ASSEMBLY


    A279762E01
    A285177
  1. Remove the 4 fuel injector assemblies from the fuel delivery pipe.
    Text in Illustration 
    *a
    for Bank 2
    *b
    for Bank 1

    NOTICE:
    1. If the tip of the fuel injector assembly is struck or the fuel injector assembly is dropped, replace the fuel injector assembly with a new one.
    2. Pull and remove the fuel injector assembly in a straight line to avoid damaging the O-ring seal surface of the fuel delivery pipe.
    3. For re-installation, attach a tag or label to each fuel injector assembly.

    NOTICE:
    1. Pull and remove the injector in a straight line to avoid damaging to the seal surface of the delivery pipe O-rings.
    2. For reinstallation, attach a tag or label to the injector shaft.



    A279763
  1. Remove the No. 1 injector holders from the fuel injectors.



    A321983E01
  1. Using a screwdriver, remove the fuel injector insulator.
    Text in Illustration 
    *1
    Fuel Injector Insulator



    A279766E01
  1. Using a needle nose plier, remove the No. 2 fuel injector backup ring.
    Text in Illustration 
    *1
    No. 2 Fuel Injector Backup Ring
    *2
    Fuel Injector Seal
    *3
    No. 1 Fuel Injector Backup Ring

  1. Remove the fuel injector seal and No. 1 fuel injector backup ring.



7. REMOVE FUEL INJECTOR O-RING


    A279764
  1. Using the tips of a pair of needle nose pliers, pinch and pull one of the fuel injector O-ring at several points to stretch it. Repeat this for the other fuel injector O-ring.

    NOTICE:
    1. Excessively pinching the fuel injector O-ring may damage the groove of the injector.
    2. If an injector is dropped or the tip of the injector is struck, replace it with a new one.

  1. Remove the fuel injector O-ring from the injector.