Home › Engine / Hybrid System › FA20 COOLING › THERMOSTAT (for Automatic Transmission)

THERMOSTAT (for Automatic Transmission) > REMOVAL

for Preparation Click here



1. DRAIN COOLANT

NOTICE:
Do not remove the radiator cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the local regulations.



    A277916
  1. Remove the service hole cover from the front bumper under cover.

  1. Connect a hose with an inside diameter of 8 mm (0.315 in.) to the drain plug.



    A277917
  1. Loosen the radiator drain cock plug.



    A279728
  1. Open the air bleed plug on the heater hose side. (for LHD)



    A279727
  1. Open the air bleed plug on the heater hose side. (for RHD)

  1. Remove the radiator cap and drain the coolant.



2. REMOVE INTAKE MANIFOLD
(Click here)


3. DISCONNECT WATER HOSE


    A281439
  1. Loosen the hose clamp and disconnect the water hose from the water inlet housing.



4. DISCONNECT WATER INLET HOUSING


    A281440
  1. Remove the 2 bolts and water inlet housing.



5. REMOVE THERMOSTAT
  1. Remove the thermostat.

  1. Remove the gasket from the thermostat.