Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

DTC    P0882    TCM Power Input Signal Low

for Preparation Click here


DESCRIPTION

TCM detects a reduction in power supply voltage, and depending on status, implements the following fail-safe.
  1. Learning control prohibition (when detection conditions 1 or 2 are met)
  2. Slip control, lock-up control, manual mode, shift paddle operation prohibition, torque up prohibition, and prohibition on shifting to 5th or 6th. If this continues further, power is cut to all solenoids (fixed to 4th).

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P0882
  1. The engine speed and input speed sensor NT are 400 rpm or more, and the CAN communication and input speed NT are normal
  2. Ignition voltage is 9.0 V or less
  3. Continues for 20 sec.
  4. 1-trip detection logic
  1. IG circuit
  2. Harness and connector
  3. TCM

WIRING DIAGRAM


C250079E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses circuits related to this system before performing the following inspection procedure.

1.CHECK TCM (POWER SOURCE, GROUND)
  1. Disconnect the A18 TCM connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A18-34(IG1) - Body ground
    Ignition switch ON
    11 to 14 V
    A18-35(IG2) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A18-3(E02) - Body ground
    Always
    Below 1 Ω
    A18-33(E01) - Body ground
    Always
    Below 1 Ω

  1. Connect the A18 TCM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, BODY GROUND)
OK


2.REPLACE TCM
  1. Replace the TCM (Click here).


NEXT

PERFORM THE RESET MEMORY (Click here)