Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

DTC    P1817    Manual Mode Switch Circuit Malfunction

for Preparation Click here


DESCRIPTION

A signal from the manual mode switch assembly input into the TCM detects the M position.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P1817
  1. Shift position sensor is normal, and not in learning control prohibited status.
  2. The shift lever is in P, N, or R, and the M switch is on.
  3. Continues for 2 sec.
  4. 1-trip detection logic
  1. Manual mode switch
  2. Harness and connector
  3. TCM

WIRING DIAGRAM


C259257E01


INSPECTION PROCEDURE

1.CHECK MANUAL MODE SWITCH
  1. Disconnect the A19 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Shift Position
    Specified Condition
    A19-8(M) - Body ground
    M
    Below 1 Ω
    A19-8(M) - Body ground
    Except M
    10 kΩ or higher

  1. Connect the A19 TCM connector.



NG
Go to step 3
OK


2.REPLACE TCM
  1. Replace the TCM (Click here).


NEXT

PERFORM THE RESET MEMORY (Click here)  

3.CHECK HARNESS AND CONNECTOR (MANUAL MODE SWITCH - SHIFT POSITION INDICATOR)
  1. Disconnect the D36 shift position indicator connector.

  1. Disconnect the D28 manual mode switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-6(MM) - D28-10(MM+)
    Always
    Below 1 Ω
    D36-6(MM) - Body ground
    Always
    10 kΩ or higher
    D28-10(MM+) - Body ground
    Always
    10 kΩ or higher

  1. Connect the D36 shift position indicator connector.

  1. Connect the D28 manual mode switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT MANUAL MODE SWITCH
  1. Disconnect the D28 manual mode switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Shift Position
    Specified Condition
    D28-10(MM+) - D28-11(MM-)
    M
    Below 1 Ω
    Except M
    10 kΩ or higher

  1. Disconnect the D28 manual mode switch connector.



NG
REPLACE MANUAL MODE SWITCH (Click here)
OK


5.CHECK HARNESS AND CONNECTOR (TCM - SHIFT POSITION INDICATOR)
  1. Disconnect the A19 TCM connector.

  1. Disconnect the D36 shift position indicator connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-5(M) - A19-8(M)
    Always
    Below 1 Ω
    D36-5(M) - Body ground
    Always
    10 kΩ or higher
    A19-8(M) - Body ground
    Always
    10 kΩ or higher

  1. Connect the A19 TCM connector.

  1. Connect the D36 shift position indicator connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SHIFT POSITION INDICATOR (Click here)