DTC B278A Short to GND in Immobiliser System Power Source Circuit |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B278A | A short to GND in the power supply of the transponder key amplifier of the engine switch (VC5 - VC5) (1 trip detection logic*1). |
| With the shift lever in P*2, the electrical key transmitter sub-assembly is held against the engine switch and an engine start operation is performed by pressing and holding the engine switch when the transmitter battery is depleted. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started when transmitter battery is depleted by holding electrical key transmitter sub-assembly against engine switch and pressing and holding engine switch with shift lever in P* | - |
| DTC Code | Data List and Active Test |
| B278A | - |

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH) |
Disconnect the D41 certification ECU (smart key ECU assembly) connector.
Disconnect the D25 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D41-1 (VC5) - D25-10 (VC5) | Always | Below 1 Ω |
| D41-24 (AGND) - D25-6 (AGND) | Always | Below 1 Ω |
| D41-1 (VC5) - Body ground | Always | 10 kΩ or higher |
| D41-24 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the D41 certification ECU (smart key ECU assembly) connector.
Reconnect the D25 engine switch connector.
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | D25-10 (VC5) - D25-6 (AGND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Condition | Engine switch off, key not inside vehicle, and within 30 seconds after engine switch pushed |
| *a | Component with harness connected (Engine Switch) |
|
| ||||
| OK | ||
| ||