Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B1571    Immobiliser Key Check NG

for Preparation Click here


DESCRIPTION

The ECM stores this code if the certification ECU (smart key ECU assembly) reference code and the reference code from the ECM do not match.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B1571
The ECM reference code and reference code from the certification ECU (smart key ECU assembly) do not match (1 trip detection logic*).
  1. ECM
  2. Certification ECU (smart key ECU assembly)
Engine switch on (IG)
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B1571
-

INSPECTION PROCEDURE

NOTICE:
  1. Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) (Click here).
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

  1. Check that the engine can be started.

OK:
The engine can be started.



NG
Go to step 2
OK

END 

2.REPLACE ECM
  1. Temporarily replace the ECM with a new one (Click here).


NEXT


3.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

  1. Check that the engine can be started.

OK:
The engine can be started.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (ECM WAS DEFECTIVE)