FRONT AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL FRONT AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Incorrect | *b | Correct |
Connect the connector to the front airbag sensor.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Connection is Completed | - | - |
Engage the 2 hooks and install the front airbag sensor with the 2 bolts.
Check that there is no looseness in the installation parts of the front airbag sensor.
| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 3. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 4. INSPECT SRS WARNING LIGHT |