FRONT SEAT SIDE AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF FRONT SEAT AIRBAG ASSEMBLY (When Installed in Vehicle) |
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connector from the front seat airbag assembly under the front seat assembly.
![]() |
Slide the slider to release the lock, and then disconnect the yellow airbag connector as shown in the illustration.
| *a | Slider |
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
Connect the SST connector to the front seat airbag assembly connector.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front side window.
| *1 | Battery |
| *a | 10 m (32.8 ft.) or more |
Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the front seat airbag assembly.
| 3. DISPOSE OF FRONT SEAT AIRBAG ASSEMBLY (When not Installed in Vehicle) |
Remove the front seat airbag assembly (Click here).
![]() |
Using braided wire, tie down the front seat airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *a | Wire Diameter |
![]() |
Install the 2 nuts to the front seat airbag assembly.
![]() |
Wind the wires around the stud bolts of the front seat airbag assembly as shown in the illustration.
![]() |
Position the front seat airbag assembly inside the tire.
| *a | Width |
| *b | Inner Diameter |
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
After connecting the following SST to each other, connect them to the front seat airbag assembly.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the front seat airbag assembly is tied.
| *1 | Tires (2 or more) |
Place at least 2 tires onto the tire to which the front seat airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
![]() |
Deploy the airbag.
| *1 | Front Seat Airbag Assembly |
| *2 | Battery |
| *a | 10 m (32.8 ft.) or more |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the front seat airbag assembly is tied.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the front seat airbag assembly.
Dispose of the front seat airbag assembly.
Remove the front seat airbag assembly from the tire.
Place the front seat airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.