Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

    NOTICE:
    Hang the caliper using a piece of string or equivalent.



3. REMOVE FRONT DISC


    C184280E03
  1. Place matchmarks on the front disc and front axle hub.

    HINT:
    It is not necessary when replacing the disc.

    Text in Illustration 
    *a
    Matchmark

  1. Remove the front disc.



4. REMOVE FRONT AXLE HUB BOLT


  1. Using SST, remove the front axle hub bolt from the front axle hub sub-assembly.


    C265372E01


    Text in Illustration 
    *1
    Nut
    *2
    Body
    *3
    Claw
    *4
    SST (Spacer B)
    *a
    Place a Wrench Here
    -
    -
    V100135
    Molybdenum Grease
    V100136
    Turn
    SST
    09960-20010   (09961-02010, 09961-02060)

    CAUTION:
    Before working, apply molybdenum grease to the bolt threads and bolt tip of SST.

    NOTICE:
    1. Install SST so that claw and body are parallel.
    2. Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
    3. Do not damage the front disc brake dust cover.
    4. Do not damage the front axle hub.
    5. Do not damage the steering knuckle.



5. INSTALL FRONT AXLE HUB BOLT


    C257542E01
  1. Set a new axle hub bolt onto the front axle hub, and tighten the nut (M12 x P1.25mm (0.0492 in.)) through the washer plate to install the axle hub bolt.
    Text in Illustration 
    *1
    Nut
    *2
    Washer
    *a
    Turn
    *b
    Hold

    NOTICE:
    Install the nuts to prevent damage to the front axle hub bolts.



6. INSTALL FRONT DISC
  1. When reusing the disc

    1. Align the matchmarks placed when removing, and install the front disc to the axle hub.

  1. When replacing the front disc

    1. Install a new front disc to the axle hub and measure the disc runout (Click here).

  1. Temporarily tighten the hub nut and fix the front disc to the axle hub.



7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Install the front disc brake caliper assembly to the steering knuckle with the 2 new bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }