Home › Engine / Hybrid System › FA20 FUEL › FUEL PRESSURE SENSOR

FUEL PRESSURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE SENSOR


    A282919E01
  1. Using SST, install the new fuel pressure sensor to the No. 1 fuel delivery pipe sub-assembly RH.

    SST
    09922-10010  

    Torque:
    Without SST:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }
    With SST:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    1. Ensure that no oil adheres to the threads of the fuel pressure sensor and No. 1 fuel delivery pipe sub-assembly RH.
    2. Do not allow foreign objects to enter when assembling the fuel pressure sensor.

    HINT:
    1. Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    1. Make sure SST and the wrench are connected in a straight line.

  1. Connect the fuel pressure sensor connector.



2. INSTALL NO. 2 ENGINE HANGER


    A279574
  1. Install the No. 2 engine hanger to the cylinder block (for bank 1) with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }



3. INSTALL INTAKE MANIFOLD
(Click here)