Home › Engine / Hybrid System › FA20 FUEL › FUEL PUMP (for High Pressure)

FUEL PUMP (for High Pressure) > REMOVAL

for Preparation Click here



1. REMOVE INTAKE MANIFOLD
(Click here)


2. REMOVE NO. 2 FUEL DELIVERY PIPE


    A279756
  1. Using a union nut wrench, loosen the 2 union nuts and remove the No. 2 fuel delivery pipe.

    NOTICE:
    When removing the No. 2 fuel delivery pipe, pull it out in a straight line to avoid damaging the O-ring seal surface of the fuel delivery pipe LH.



3. DISCONNECT FUEL DELIVERY PIPE SUB-ASSEMBLY


    A281427
  1. Remove the union bolt and gasket, and disconnect the fuel delivery pipe sub-assembly.



4. REMOVE FUEL PUMP ASSEMBLY


    A280563
  1. Using a "TORX" Plus Socket Wrench, remove the 2 bolts and fuel pump assembly.

  1. Remove the O-ring from the fuel pump assembly.



5. REMOVE VALVE LIFTER


    A280564
  1. Remove the valve lifter from the pump drive case assembly.



6. REMOVE PUMP DRIVE CASE ASSEMBLY


    A278730
  1. Using a 6 mm hexagon wrench, remove the 3 bolts and pump drive case assembly.