Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > Transmission Control Switch Circuit

for Preparation Click here


DESCRIPTION

When the shift lever is in M, it is possible to change into any gear using the floor shift lever assembly sequential gate.

WIRING DIAGRAM


C259539E01


INSPECTION PROCEDURE

1.INSPECT TRANSMISSION CONTROL SWITCH
  1. Disconnect the D28 transmission control switch connector.

  1. Perform inspection of the transmission control switch .



NG
REPLACE TRANSMISSION CONTROL SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL SWITCH - TCM)
  1. Disconnect the A19 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Shift Position
    Specified Condition
    A19-1(SFTU) - Body ground
    Press continuously
    "+"
    (Up shift)
    Below 1 Ω
    M
    10 kΩ or higher
    A19-2(SFTD) - Body ground
    Press continuously
    "-"
    (Down shift)
    Below 1 Ω
    M
    10 kΩ or higher

  1. Connect the A19 TCM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TCM
  1. Replace the TCM (Click here).


NEXT

PERFORM THE RESET MEMORY (Click here)