Home › Engine / Hybrid System › FA20 ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit, which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is turned to ON, the MIL should be illuminated and should turn off after engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.

WIRING DIAGRAM


A280176E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the table below.

    Result 
    Result
    Proceed to
    MIL remains ON
    A
    MIL does not illuminate
    B
    MIL illuminates for several seconds, but turns off after engine is started
    C



B
Go to step 3

C
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A


2.CHECK WHETHER MIL TURNS OFF
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine / Trouble Codes.

  1. Check if any DTCs have been detected. Note down any DTCs.

    Result 
    Result
    Proceed to
    No DTC detected
    A
    Any DTCs detected
    B

    HINT:
    Check for detected DTCs output from other ECUs which relate to the MIL.



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A

GO TO METER / GAUGE SYSTEM (Click here)  

3.CHECK THAT ENGINE STARTS
  1. Turn the ignition switch to ON.

  1. Start the engine.

    Result 
    Result
    Proceed to
    Engine starts
    A
    Engine does not start*
    B

    HINT:
    *: The GTS cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT (Click here)
A

REPLACE COMBINATION METER (Click here)