Home › Engine / Hybrid System › FA20 ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

The Malfunction Indicator Light (MIL) is used to indicate vehicle malfunctions detected by the ECM.
The MIL operation can be checked visually. When the ignition switch is turned to ON, the MIL should be illuminated and should then turn off after engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.

WIRING DIAGRAM


A280176E31


INSPECTION PROCEDURE

1.CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the table below.

    Result 
    Result
    Condition
    Proceed to
    MIL ON → MIL OFF
    Ignition switch ON → Engine is started
    A
    Other than the above
    -
    B



B
Go to step 2
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)  

2.CHECK CONNECTION BETWEEN GTS AND ECM
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Checking the Data List for "Engine" is possible.

    Result 
    Result
    Proceed to
    Communication is possible
    A
    Communication is not possible
    B



B
GO TO VC OUTPUT CIRCUIT (Click here)
A


3.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: System Select / Health Check.

  1. Check if any DTCs have been detected. Note down any DTCs.

    Result 
    Result
    Proceed to
    DTCs are not output
    A
    DTCs are output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT
A


4.PERFORM ACTIVE TEST USING GTS (CHECK MIL)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test / Check Engine Warning

  1. Check the status of the MIL while performing the Active Test.

    Result 
    Result
    Proceed to
    Changes
    A
    Does not change
    B



B
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPLACE ECM (Click here)