ENTRY AND START SYSTEM (for Start Function) > SYSTEM DESCRIPTION |
| PRECAUTION FOR REGISTRATION |
If replacing any of the following parts, refer to the Service Bulletin.
ID code box (immobiliser code ECU)*
Certification ECU (smart key ECU assembly)
ECM
Steering lock actuator assembly (steering lock ECU)
Electrical key transmitter sub-assembly
| SYSTEM FUNCTION |
| Function | Outline |
| Ignition function | When the electrical key transmitter sub-assembly is brought into the vehicle and verified, this function changes the power source or starts the engine when the engine switch and brake pedal*1 or clutch pedal*2 are operated. |
| Battery saving function for vehicle | When the vehicle is not used for a long time, this function extends the interval between each periodic transmission of the request signal, or stops transmission of the request signal to save vehicle battery power.
|
| Battery saving function for electrical key transmitter sub-assembly | If a switch on the electrical key transmitter sub-assembly is depressed and held, this function stops transmission of the signal after approximately 20 seconds to save electrical key transmitter sub-assembly battery power. |
| Entry cancel function | Cancels the entry and start system when certain operations are performed. |
| Immobiliser function | Allows the engine to be started only using registered electrical key transmitter sub-assemblies to prevent an unauthorized engine start. |
| Automatic power off function | for Automatic Transmission
for Manual Transmission
|
| DETECTION AREA |
The request signal sent from the certification ECU (smart key ECU assembly) is transmitted from each electrical key antenna (outside) to form the detection area. The detection area formed by each electrical key antenna (outside) has a detection range of 0.7 to 1 m (2.30 to 3.28 ft.) from the door handles and rear bumper (electrical key antenna (outside luggage).
When the vehicle is parked (the power is off and the doors are locked*), the detection area of each electrical key antenna (outside) is formed by emitting a periodic request signal every 0.25 seconds in order to detect the electrical key transmitter sub-assembly. Also, when the doors are locked and a lock sensor is touched, a request signal is emitted, the detection area outside the vehicle is formed and the electrical key transmitter sub-assembly is detected.
The detection area of the electrical key antenna (outside luggage) is formed when the back door opener switch assembly is pressed.
The detection area inside the vehicle is formed and the electrical key transmitter sub-assembly is detected when any of the following conditions are met: 1) Any door is opened and closed, 2) the brake pedal*1 or clutch pedal*2 is depressed, 3) the engine switch is operated, 4) the conditions required for various warnings are met, or 5) an entry door lock operation is performed.
The detection area inside the vehicle when starting the engine can be customized through the customize function (Click here).