TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble.
| |||||
| 3.ADJUST TIRE PRESSURE* |
Turn the ignition switch off.
Set all tire pressures to the specified value (Click here).
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Check the Data List (Click here).
| Condition | Proceed to |
| Tire pressure warning light remains on | A |
| Tire pressure warning light goes off | B |
|
| ||||
| |||||
| 4.CHECK ECU CONNECTED TO CAN BUS* |
Check the ECUs connected to the CAN bus (Click here).
| Result | Proceed to |
| No malfunction appears | A |
| Malfunction appears | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)* |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN system DTC is not output | A |
| CAN system DTC is output | B |
|
| ||||
| |||||
| 6.CHECK FOR DTC* |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| |||||
| 7.DTC CHART |
Refer to Diagnostic Trouble Code Chart (Click here).
|
| ||||
|---|---|---|---|---|---|
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| |||||
| 9.CIRCUIT INSPECTION* |
Refer to Electronic Circuit Inspection Procedure (Click here).
| |||||
| 10.REPAIR OR REPLACE |
Repair or replace parts based on the diagnosis result.
| |||||
| 11.CONFIRMATION TEST* |
Check the Data List to confirm that the tire inflation pressure has been received (Click here).
|
| ||||
|---|---|---|---|---|---|