Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Entry Function)

ENTRY AND START SYSTEM (for Entry Function) > Entry Interior Alarm does not Sound

for Preparation Click here


DESCRIPTION

The entry and start system (for Entry Function) uses the buzzer in the combination meter assembly to perform various vehicle interior warnings. When the conditions of each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the combination meter assembly via CAN communication and the buzzer sounds.

INSPECTION PROCEDURE

NOTICE:
  1. The entry and start system (for Entry Function) uses a LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the entry and start system (for Entry Function) after confirming that the communication system is functioning properly.
  2. Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) (Click here).

1.CHECK ENTRY DOOR LOCK OPERATION
  1. Check that the entry functions operate normally (Click here).

OK:
Entry functions operate normally.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK

GO TO METER / GAUGE SYSTEM (PROCEED TO PROBLEM SYMPTOMS TABLE) (Click here)