Function
| Outline
|
All door lock function*1
| Pressing the lock switch locks all doors.
|
All door unlock function (Unlock 2 operation)*2
| Pressing the unlock switch twice within 5 seconds unlocks all the doors after the driver door is unlocked.
|
Luggage compartment door open
| Pressing the luggage door open switch of the door control transmitter module set sub-assembly for longer than about 0.8 seconds opens the luggage compartment door.
|
Answer-back function (Hazard warning light)
| Hazard warning lights flash once when doors are locked, and flash twice when doors are unlocked to indicate that the request has been completed.
|
Answer-back function (Wireless door lock buzzer))*3
| Wireless door lock buzzer sound once when doors are locked, and sound twice when doors are unlocked to indicate that the request has been completed.
|
Panic alarm function*2
| Pressing the panic switch of the door control transmitter for longer than about 0.8 seconds causes the following alarms to activate:
- Sound the vehicle horns.
- Blinks the headlights, hazard warning lights and taillights.
- Illuminates the interior lights (when the interior light door switch on).
While the panic alarm is operating, pressing any switch of the door control transmitter cancels the alarm operation.
|
Vehicle Position Sensing Function*4
| The vehicle position sensing function is a function that sounds the vehicle horn and flashes the hazard warning lights by operating the transmitter in order to indicate the vehicle's position to the user.
|
Door ajar warning function*5
| The buzzer sounds when the lock switch is pressed when any of the doors are ajar, and it sounds for 10 seconds continuously. The buzzer stops when all doors are closed or the unlock switch is pressed.
|
Automatic locking function
| If no doors are opened within 30*1 or 60*2 seconds after being unlocked by wireless transmitter, all doors are locked again automatically.
|
Illuminated entry function
| When all the doors are locked, pressing unlock causes the interior light to come on simultaneously with the unlock operation.
|
Self-diagnostic function
| The system enters self-diagnostic mode under the following conditions.
- If the door control receiver receives normal radio waves from the door control transmitter when the system is in diagnostic mode, it flashes the interior light in a normal pattern that corresponds to the function of each switch.
|
Transmitter recognition code registration function
| Enables 4 modes for registering (writing and storing) transmitter recognition codes in EEPROM, built into door control receiver.
|