AIRBAG SYSTEM > SRS Warning Light does not Come ON |

| 1.CHECK BATTERY VOLTAGE |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 2.CHECK CONNECTOR |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Check that the connector is properly connected to the combination meter assembly.
Disconnect the connector from the combination meter assembly.
Check that the terminal of the connector is not damaged.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-1 (B) - Body ground | Always | 11 to 14 V |
| D7-2 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-20 (ES1) - Body ground | Always | Below 1 Ω |
| D7-40 (ES2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 4.CHECK SRS WARNING LIGHT |
Disconnect the cable from the negative (-) battery terminal.
Connect the connector to the combination meter assembly.
Disconnect the connector from the airbag ECU assembly.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||