Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    U0073    Control Module Communication Bus "A" Off

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0101    Lost Communication with TCM

DTC    U0126    Lost Communication with Steering Angle Sensor Module

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the ECM, steering sensor and TCM via the CAN communication system.

DTC No.
DTC Detection Condition
Trouble Area
U0073
The +BS terminal voltage is between 9.6 and 16.5 V and bus off is judged for 0.1 seconds or more.
CAN communication system
U0100
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the ECM for 0.5 seconds or more.
  1. CAN communication system
  2. Skid control ECU (Brake actuator assembly)
  3. ECM
U0123
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the TCM for 0.5 seconds or more.
  1. CAN communication system
  2. Skid control ECU (Brake actuator assembly)
  3. TCM
U0126
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals from the steering sensor cannot be received for 0.1 seconds or more.
  1. CAN communication system
  2. Skid control ECU (Brake actuator assembly)
  3. steering sensor

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. Drive the vehicle at a speed of 15 km/h (9 mph) or more and turn the steering wheel to the right and left.

  1. Check that no CAN communication system DTC is output (Click here).

  1. If VSC system DTCs are output, record them (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B
    CAN communication system DTC is output.
    C

    HINT:
    The CAN communication system must be normal when performing troubleshooting for sensor DTCs (for VSC system).



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)

C
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)