CAN COMMUNICATION SYSTEM > Bus Buffer ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Bus Buffer ECU Communication Stop Mode | Communication system DTCs (DTCs that start with U) that are output correspond to "Bus Buffer ECU Communication Stop Mode" in "DTC Combination Table" (Click here) | PSP (option connector) branch line or connector |


| 1.CHECK FOR OPEN IN CAN BUS LINES (PSP (OPTION CONNECTOR) BRANCH LINE) |
![]() |
Disconnect the cable from the negative (-) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D29-4 (CANH) - D29-5 (CANL) | Cable disconnected from negative (-) battery terminal | 57 to 63 Ω |
| *a | Front view of wire harness connector (to PSP (Option Connector)) |
|
| ||||
| OK | ||
| ||