Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power for main body ECU (network gateway ECU) operation.

WIRING DIAGRAM


B316997E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
  1. Disconnect the 3A and 3C instrument panel junction block assembly connectors.



    B317020E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    3A-27 - Body ground
    Always
    11 to 14 V
    3C-19 - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Instrument Panel Junction Block Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BODY GROUND)
  1. Disconnect the 3B instrument panel junction block assembly connector.

  1. Disconnect the A73 and D6 main body ECU (network gateway ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3B-18 - Body ground
    Always
    Below 1 Ω
    A73-4 (GND )- Body ground
    Always
    Below 1 Ω
    D6-1 (GND - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).

  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.


B316998E02


Text in Illustration 
*a
Component without harness connected
(Instrument Panel Junction Block Assembly
-
-
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    3A-27 - MB-1 (BECU)
    Always
    Below 1 Ω
    3C-19 - MB-32 (BMPX)
    Always
    Below 1 Ω
    3B-18 - MB-11 (GND
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)