Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > INSPECTION

for Preparation Click here



1. CHECK BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust and scoring. If necessary, replace the disc brake cylinder and piston.



2. CHECK PAD LINING THICKNESS


    C256656
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    11.0 mm (0.4331 in.)

    Minimum thickness:
    1.5 mm (0.0591 in.)

    If the pad lining thickness is lower/under the minimum, replace the pad.



3. CHECK DISC THICKNESS


    C256657
  1. Using a micrometer, measure the disc thickness.

    Standard Thickness:
    24.0 mm (0.945 in.)

    Minimum Thickness:
    22.0 mm (0.866 in.)



4. CHECK DISC RUNOUT


    C256653E01
  1. Check the bearing play in the axial direction and check the axle hub runout (Click here).

  1. Tighten the disc with the 5 nuts.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.
    Text in Illustration 
    *1
    Dial Indicator

    Maximum disc runout:
    0.05 mm (0.0020 in.)

    NOTICE:
    1. Do not bring the magnetic base near the axle hub and speed sensor.
    2. Set the magnetic base on the shock absorber.
    3. If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, replace the front disc.

  1. Remove the 5 hub nuts and front disc.