FRONT SEAT OUTER BELT ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (When Installed in Vehicle) |
Disconnect the seat belt pretensioner connector.
Disconnect the cable from the negative (-) battery terminal.
Remove the luggage compartment trim cover .
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the pretensioner connector lock and disconnect the pretensioner connector.
| *1 | Protective Tape |
| *2 | Pretensioner Connector |
| *3 | Pretensioner Connector Lock |
Connect SST.
![]() |
Short the clip and terminal of SST.
| *a | Short the clip and terminal |
Connect 2 SST, and then connect them to the seat belt pretensioner.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front of the vehicle.
| *a | 10 m (32.8 ft.) or more |
Close all the doors and windows of the vehicle.
Deploy the seat belt pretensioner.
Confirm that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Connect the clip of SST to the battery positive (+) terminal.
Connect the terminal of SST to the battery (-) terminal to the deploy the seat belt pretensioner.
Dispose of the front seat outer belt assembly.
Remove the front seat outer belt assembly and SST.
Place the front seat outer belt assembly in a plastic bag, tie the end tightly, and dispose of it in the same way as other general parts.
| 2. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (When Not Installed in Vehicle) |
Remove the front seat outer belt assembly (Click here).
![]() |
Wind the seat belt webbing with the retractor.
| *a | Cut |
| *b | 100 mm (3.94 in.) |
When the seat belt webbing is sufficiently wound, cut the seat belt webbing approximately 100 mm (3.94 in.) from the retractor, as shown in the illustration.
Connect SST.
![]() |
Short the clip and terminal of SST.
| *a | Short the clip and terminal |
Connect 2 SST, and then connect them to the seat belt pretensioner.
![]() |
Place the front seat outer belt assembly on the ground and cover it with a tire and wheel assembly.
| *a | 10 m (32.8 ft.) or more |
Position and hold SST at least 10 m (32.8 ft.) away from the wheel.
Deploy the seat belt pretensioner.
Check that no one is within a 10 m (32.8 ft.) radius of the wheel.
Connect the clip of SST to the battery positive (+) terminal.
Connect the terminal of SST to the battery (-) terminal to the deploy the seat belt pretensioner.
Dispose of the front seat outer belt assembly.
Remove the wheel and SST.
Place the front seat outer belt assembly in a plastic bag, tie the end tightly, and dispose of it in the same way as other general parts.