Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > IG Signal Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the ignition switch ON or off condition, and sends it to the main body ECU (network gateway ECU).

WIRING DIAGRAM


E249225E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Read the display on the GTS.

    OK:
    Normal conditions listed above are displayed.


    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch ON signal/ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BATTERY AND BODY GROUND)
  1. Disconnect the 3A and 3E instrument panel junction block assembly connectors.



    E249590E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    3E-1 - Body ground
    Always
    11 to 14 V
    3A-15 - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3A-12 - Body ground
    Always
    Below 1 Ω
    3A-13 - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to instrument panel junction block assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (IG1 NO. 1 RELAY)
  1. Remove the instrument panel junction block assembly (Click here).

  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.



  1. Measure the resistance according to the value(s) in the table below.


    E249226E01


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument panel junction block assembly)
    -
    -

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3E-1 - MB-8 (IG)
    Always
    10 kΩ or higher
    3E-1 - MB-8 (IG)
    Battery positive (+) → 3A-15
    Battery negative (-) → 3A-12 or 3A-13
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)