Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Luggage Compartment Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) detects the condition of the luggage compartment door lock assembly using this circuit.

WIRING DIAGRAM


E249232E01


INSPECTION PROCEDURE

1.READ VALUE USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Read the display on the GTS.

    OK:
    Normal conditions listed above are displayed.


    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Luggage Courtesy SW
    Luggage compartment door courtesy switch signal/ON or OFF
    ON: Luggage compartment door open
    OFF: Luggage compartment door closed
    -



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT LUGGAGE DOOR CLOSER ASSEMBLY
  1. Remove the luggage door closer assembly (Click here).



    B175598E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Door Lock Condition
    Specified Condition
    3 (D+) - 2 (E)
    Open (Unlock)
    Below 1 Ω
    3 (D+) - 2 (E)
    Close (Lock)
    10 kΩ or higher

Text in Illustration 
*a
Component without harness connected
(Luggage Door Closer Assembly)
*b
Close (Lock)
*c
Open (Unlock)


NG
REPLACE LUGGAGE DOOR CLOSER ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (LUGGAGE DOOR CLOSER ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
  1. Disconnect the 3D instrument panel junction block assembly connector.

  1. Disconnect the J3 luggage door closer assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J3-3 (D+) - 3D-26
    Always
    Below 1 Ω
    J3-3 (D+) - Body ground
    Always
    10 kΩ or higher
    J3-2 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).

  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.



  1. Measure the resistance according to the value(s) in the table below.


    E249233E01


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3D-26 - MB-12
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)