Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP

VACUUM PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VACUUM PUMP ASSEMBLY OPERATION


    C260988
  1. Move the clamp and disconnect the vacuum tube connector hose from the vacuum pump assembly.



    C260989E01
  1. Connect the hose of a vacuum gauge to the vacuum pump assembly.
    Text in Illustration 
    *1
    Vacuum Gauge

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, check the vacuum of the vacuum pump assembly.

    Standard pressure:
    More than 93 kPa (698 mmHg, 27 in.Hg) of vacuum

    If the is not as specified, disassemble the vacuum pump assembly and inspect or replace it (Click here).

    HINT:
    After disassembling and checking the vacuum pump assembly, check the vacuum pump assembly function.

  1. Remove the vacuum gauge from the vacuum pump assembly.

  1. Connect the vacuum tube connector hose to the vacuum pump and move the clamp back into position.