Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL SWITCH (for RHD)

CLUTCH PEDAL SWITCH (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH SWITCH ASSEMBLY
  1. Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the clutch switch connector.



    C263919E01
  1. Without depressing the clutch pedal, check that there is no clearance between the switch shaft and the clutch pedal stopper.
    Text in Illustration 
    *a
    No Clearance

    HINT:
    Do not turn the clutch switch assembly.



2. INSTALL CLUTCH START SWITCH ASSEMBLY
  1. Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the clutch start switch connector.



    C261062E01
  1. With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.
    Text in Illustration 
    *a
    Clearance

    Standard clearance:
    3.2 to 4.6 mm (0.1260to 0.1811in.)

    HINT:
    Do not turn the clutch start switch assembly.



3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



5. INSPECT CLUTCH START SYSTEM
  1. Check that the engine does not start when the clutch pedal is released.

  1. Check that the engine starts when the clutch pedal is fully depressed.
    If necessary, replace the clutch start switch assembly.