Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL SWITCH (for LHD)

CLUTCH PEDAL SWITCH (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:
Use the same procedure as for the RH side.



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


4. REMOVE CLUTCH SWITCH ASSEMBLY
  1. Disconnect the clutch switch connector.



    C263917
  1. Remove the nut and the clutch switch assembly from the clutch pedal support sub-assembly.

    HINT:
    Do not turn the clutch switch assembly.



5. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
(Click here)


6. REMOVE CLUTCH START SWITCH ASSEMBLY
  1. Disconnect the clutch start switch connector.



    C263916
  1. Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.

    HINT:
    Do not turn the clutch start switch assembly.