Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > INSPECTION

for Preparation Click here



1. CHECK BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust and scoring.



2. INSPECT PAD LINING THICKNESS


    C262317
  1. Using a ruler, measure the pad lining thickness.
    Specification
    Minimum Thickness
    Standard Thickness
    Solid Type
    1.5 mm (0.059 in.)
    9.0 mm (0.354 in.)
    Ventilated Type
    1.5 mm (0.059 in.)
    11.0 mm (0.433 in.)



3. INSPECT DISC THICKNESS


    C256658
  1. Using a micrometer, measure the disc thickness.
    Specification
    Minimum Thickness
    Standard Thickness
    Solid Type
    8.5 mm (0.3346 in.)
    10.0 mm (0.3937 in.)
    Ventilated Type
    16.5 mm (0.6496 in.)
    18.0 mm (0.7087 in.)



4. INSPECT DISC RUNOUT


    C256654E01
  1. Check the bearing play in the axial direction and check for the axle hub runout (Click here).

  1. Tighten the disc with the 5 nuts.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.
    Text in Illustration 
    *1
    Dial Indicator

    Maximum disc runout:
    0.05 mm (0.0020 in.)

    NOTICE:
    1. If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, replace the front disc.

  1. Remove the 5 hub nuts and rear disc.