CAN COMMUNICATION SYSTEM > Combination Meter ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Combination Meter ECU Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (COMBINATION METER ASSEMBLY BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the D7 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-6 (CANH) - D7-7 (CANL) | Cable disconnected from negative (-) battery terminal | 57 to 63 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-20 (ES1) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| D7-40 (ES2) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-1 (B) - Body ground | Ignition switch off | 11 to 14 V |
| D7-2 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||