TIRE PRESSURE WARNING VALVE > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
Install a new grommet to the tire pressure warning valve and transmitter.
![]() |
Insert the tire pressure warning valve and transmitter into the valve installation hole from the inside of the rim so that the printed surface can be seen.
| *a | Printed Surface |
| *b | 7-digit Number Transmitter ID |
![]() |
From the outside of the rim, install a new washer onto the tire pressure warning valve and transmitter, and tighten a new nut.
| *1 | Tire Pressure Warning Valve and Transmitter |
| *2 | Rim |
| *3 | Grommet |
| *4 | Washer |
| *5 | Nut |
![]() |
Set the tire and disc wheel onto the mounting machine.
| *a | Rim |
| *b | Mount Tool of the Mounting Machine |
| *c | Area for Tire Pressure Warning Valve and Transmitter |
![]() | Rim Rotating Direction |
Apply a sufficient coat of soapy water or equivalent to the tire bead and rim.
Using a mounting machine, install the tire to the disc wheel.
Install the new valve core.
After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque.
Check for air leaks with soapy water.
If there is air leakage, push the valve core 2 or 3 times to remove any dirt attached to the valve core. If air continues to leak, replace the grommet, washer and nut.
Install the cap.
| 2. INSTALL FRONT WHEEL |
| 3. INSTALL REAR WHEEL |
| 4. INSPECT TIRES |
Check the tires for wear and proper inflation pressure.
| Tire Size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| 205/55R16 91V | 240 (2.4, 35) | 240 (2.4, 35) |
| 215/45R17 87W | 240 (2.4, 35) | 240 (2.4, 35) |
| T135/80D 16 101M | 420 (4.2, 60) | 420 (4.2, 60) |
![]() |
Using a dial indicator, check the runout of the wheel.
| Steel wheel | 2.0 mm (0.0787 in.) (Vertical and lateral) |
| Aluminum wheel | 1.0 mm (0.0394 in.) (Vertical and lateral) |
| 5. REGISTER TRANSMITTER ID |
| 6. REGISTER TRANSMITTER ID |
| 7. INSPECT TIRE PRESSURE WARNING SYSTEM |