Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



3. REMOVE AIR CONDITIONING UNIT ASSEMBLY (for Automatic Air Conditioning System)
(Click here)


4. REMOVE AIR CONDITIONING UNIT ASSEMBLY (for Manual Air Conditioning System)
(Click here)


5. REMOVE ASPIRATOR (for Automatic Air Conditioning System)


    E250772
  1. Disengage the 2 claws and remove the aspirator with aspirator pipe as a unit.



6. REMOVE ASPIRATOR PIPE (for Automatic Air Conditioning System)


    E250773
  1. Remove the aspirator pipe.



7. REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)


    E250775
  1. Disengage the 3 claws and remove the air inlet damper control cable sub-assembly.

    NOTICE:
    Hold the control cable and remove the drive gear on the unit side slowly, without pulling it.



8. REMOVE HEATER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)


    E250776
  1. Disengage the 3 claws and remove the heater control cable sub-assembly.

    NOTICE:
    Hold the control cable and remove the drive gear on the unit side slowly, without pulling it.



9. REMOVE COOLER EXPANSION VALVE


    E250751
  1. Remove the gasket.



    E250765
  1. Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and cooler expansion valve.



    E250766
  1. Remove the 2 O-rings from the evaporator pipe.



10. REMOVE COOLING UNIT CASE SUB-ASSEMBLY (for Automatic Air Conditioning System)


    E250758
  1. Disengage the clamp.



    E246468
  1. Remove the 7 screws.

  1. Disengage the 2 claws and remove the cooling unit case sub-assembly.



11. REMOVE COOLING UNIT CASE SUB-ASSEMBLY (for Manual Air Conditioning System)

HINT:
Use the same procedure as for the automatic air conditioning system.



12. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E250759
  1. Remove the No. 1 cooler evaporator sub-assembly with evaporator pipe as a unit.



13. REMOVE AIR CONDITIONER TUBE ASSEMBLY


    E250774
  1. Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and air conditioner tube assembly.



14. REMOVE NO. 1 COOLER THERMISTOR


    E250742
  1. Remove the No. 1 cooler thermistor from the No. 1 cooler evaporator sub-assembly.