Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE

WASHER NOZZLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for RHD)


  1. With the engine running, check the position where the windshield washer fluid hits the windshield.

    Standard:
    The washer fluid hits the windshield in the areas shown in the illustration.



    B310897E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    a
    684 mm (26.929 in.)
    b
    660 mm (25.984 in.)
    c
    232 mm (9.134 in.)
    d
    247 mm (9.724 in.)
    e
    250 mm (9.843 in.)
    f
    268 mm (10.551 in.)
    g
    299 mm (11.772 in.)
    h
    253 mm (9.961 in.)
    i
    250 mm (9.843 in.)
    j
    300 mm (11.811 in.)

    HINT:
    If the result is not as specified, adjust the washer nozzle sub-assembly (Click here).



2. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for LHD)


  1. With the engine running, check the position where the windshield washer fluid hits the windshield.

    Standard:
    The washer fluid hits the windshield in the areas shown in the illustration.



    B314886E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    a
    660 mm (25.984 in.)
    b
    684 mm (26.929 in.)
    c
    247 mm (9.724 in.)
    d
    232 mm (9.134 in.)
    e
    268 mm (10.551 in.)
    f
    250 mm (9.843 in.)
    g
    253 mm (9.961 in.)
    h
    299 mm (11.772 in.)
    i
    300 mm (11.811 in.)
    j
    250 mm (9.843 in.)

    HINT:
    If the result is not as specified, adjust the washer nozzle sub-assembly (Click here).