Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Horn Circuit

for Preparation Click here


DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (network gateway ECU) transmits a signal to cause the horn to sound at 0.4 second intervals.

WIRING DIAGRAM


B316996E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT HORNS
  1. Press the horn switch and check if the horns sound.
    Result 
    Result
    Proceed to
    Horns sound
    A
    Horns do not sound
    B



B
GO TO HORN SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. According to the display on the GTS, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -

    OK:
    The vehicle horns sound and stop correctly when operating them through the GTS.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)  

3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).

  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.



  1. Measure the resistance according to the value(s) in the table below.


    B314090E02


    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    MB-26 (HO) - 3D-31
    Always
    Below 1 Ω
    MB-26 (HO) - 3D-32
    Always
    Below 1 Ω


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)