Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(Click here)


2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


B314882E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not press the claw too hard, as it mat get damaged.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    B314905E01
  1. Disconnect the connector.

  1. Using pliers, expand the clamp as shown in the illustration.
    Text in Illustration 
    *1
    Clamp



    E194513
  1. While holding the clamp expanded, disengage the claw and remove the headlight dimmer switch assembly as shown in the illustration.