Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B1401    M Check NG

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) stores this code if the main body ECU (network gateway ECU) reference code and the reference code from the combination meter do not match.

DTC Code
DTC Detection Condition
Trouble Area
B1401
The main body ECU (network gateway ECU) reference code and reference code from the combination meter assembly do not match.
Combination meter assembly

INSPECTION PROCEDURE

NOTICE:
If the combination meter assembly is replaced, refer to Service Bulletin.

1.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B1407 or B1408 is not output.



NG
GO TO DTC CHART (Click here)
OK


2.REGISTER RECOGNITION CODES
  1. Register the recognition codes (Refer to Service Bulletin).

OK:
The recognition codes can be registered



NG
Go to step 3
OK

END 

3.CHECK FOR DTC
  1. Check for DTCs (Click here).

OK:
DTC B1407 or B1408 is not output.



NG
GO TO DTC CHART (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)