Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B1405    SCU Check NG

for Preparation Click here


DESCRIPTION

  1. The main body ECU (network gateway ECU) stores this code if the main body ECU (network gateway ECU) reference code and the reference code from the transponder key ECU assembly do not match.

DTC Code
DTC Detection Condition
Trouble Area
B1405
The main body ECU (network gateway ECU) reference code and reference code from the transponder key ECU assembly do not match.
Transponder key ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, refer to Service Bulletin.

1.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B1406 and B1409 are not output.



NG
GO TO DTC CHART (Click here)
OK


2.REGISTER RECOGNITION CODES
  1. Register the recognition codes (Refer to Service Bulletin).

OK:
The ECU code can be registered.



NG
Go to step 3
OK

END 

3.CHECK DTC
  1. Check for DTC (Click here).

OK:
DTC B1406 and B1409 are not output.



NG
GO TO DTC CHART (Click here)
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY