Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System)

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

This door control receiver receives signals from the transmitter and sends these signals to the main body ECU (network gateway ECU).

DTC No.
DTC Detection Condition
Trouble Area
B1242
In diagnostic mode, applicable RDA signal cannot be received 3 times in succession after the PRG signal is output from the main body ECU (network gateway ECU).
  1. Wire harness or connector
  2. Door control receiver
  3. Main body ECU (network gateway ECU)

WIRING DIAGRAM


B222320E05


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (NETWORK GATEWAY ECU) - DOOR CONTROL RECEIVER)
  1. Disconnect the D6 main body ECU (network gateway ECU) connector.

  1. Disconnect the H27 door control receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D6-6 (PRG) - H27-3 (PRG)
    Always
    Below 1 Ω
    D6-6 (PRG) or H27-3 (PRG) - Body ground
    Always
    10 kΩ or higher
    D6-7 (RDA) - H27-2 (RDA)
    Always
    Below 1 Ω
    D6-7 (RDA) or H27-2 (RDA) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT DOOR CONTROL RECEIVER (POWER SOURCE, GROUND)


    B159866E08
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H27-5 (+B) - Body ground
    Always
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H27-1 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Door Control Receiver)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE DOOR CONTROL RECEIVER
  1. Temporarily replace the door control receiver with a new or normally functioning one (Click here).


NEXT


4.REGISTER RECOGNITION CODE
  1. Perform the Registration procedures (Click here).

    HINT:
    If a new or normal functioning door control receiver is available, connect it and check if the wireless door lock function is normal or the DTC is output. If the alternative receiver functions normally, replace the original door control receiver.


NEXT


5.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


6.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC is not output.

    HINT:
    Reinstall the parts, such as sensors and connectors, and restore the vehicle to its previous conditions before rechecking for DTCs.



NG
REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)
OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)